PIONEERPOS AT Commands G24-LC - Manual (Page 267)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-203
The following table shows the S24 parameters.
Example
ATS24? <enter>
000
OK
ATS24=5 <enter>
OK
ATS24? <enter>
005
OK
(If there are no radio and UART activities, the G24-L will enter sleep mode in 5 seconds)
S102, Set Delay Before Sending Data to the Terminal
This command sets the value of the delay before sending data to the terminal. Before receiving
data, the terminal connected to the G24-L will receive:
• Terminal Wakeup signal (the Wakeup Out Line (pin #26) state will be active low).
• A delay that is equal ATS102 value.
• Data (GPRS, CSD, AT commands' echo and results, unsolicited reports).
Command Type Syntax Response/Action Remarks
Set ATS24=[<value>] OK The Set command sets the amount of
time, in seconds, the G24-L should
wait before entering Sleep mode.
Read ATS24? <value>
OK
The Read command returns the current
value.
Table 3-135: S24 Parameters
<Parameter> Description
<value> Number of seconds (0 <= n <= 255)
0
Disable Sleep mode
>0 Enable Sleep mode
The default value is 0.