PIONEERPOS AT Commands G24-LC - Manual (Page 268)

Modem Configuration and Profile
3-204 G24-L AT Commands Reference Manual April 15, 2008
The following table shows the S102 parameters.
Example
ATS102? <enter>
030
OK
ATS102=100 <enter>
OK
ATS102? <enter>
100
OK
(This means if there is data for transmission to the terminal, the G24-L drops the Wakeup Out
line, waits 100 ms. and then sends data to the terminal.)
S100, Set Minimum Time for Terminal to Fall into Sleep Mode
ATS100 is a terminal minimum time limit for entering sleep mode.
In order to limit the number of interrupts on the DTE side and reduce data sending delay time on
our side, G24-L sends wakeup-out pulse when the interval between one burst of sent/received
data to the other is bigger than specified in ATS100.
Command Type Syntax Response/Action Remarks
Set ATS102 = <value> OK The Set command sets the delay before
sending data to the terminal, and
defines a period between sending the
wakeup signal and sending data to the
terminal.
Read ATS102? <value>
OK
The Read command returns the current
value.
Table 3-136: S102 Parameters
<Parameter> Description
<value> 0 <= value <= 255
The default value is 30 ms.
Command Type Syntax Response/Action Remarks
Set ATS100=<delta> OK
Or
+CME ERROR: <err>
The set command sets the terminal
minimum time limit for entering sleep
mode.
Read ATS100? <delta>
OK
The Read command returns the current
ATS100 value.