Mipflush, flush data from buffers, Mipflush, flush data from buffers -286, Mippush parameters -286 – PIONEERPOS AT Commands G24-LC User Manual
Page 350: Mipflush parameters -286
GPRS
3-286
G24-L AT Commands Reference Manual
April 15, 2008
The following table shows the +MIPPUSH parameters.
Example
AT+MIPPUSH=1
//Terminal asks the G24-L to flush the buffer in socket 1 (was opened
using the +MIPOPEN command)
+MIPPUSH: 0
OK
+MIPFLUSH, Flush Data from Buffers
This command causes the G24-L to flush (delete) data accumulated in its accumulating buffers.
The following table shows the +MIPFLUSH parameters.
Table 3-201: +MIPPUSH Parameters
<Parameter>
Description
Socket ID
1,2,3,4Number of valid socket
Destination IP
IP of destination site in the format AAA.BBB.CCC.DDD. The value can be written in
1, 2 or 3 digits.
Destination
Port
0-65535Port of destination site. Written in decimal digits.
Command Type
Syntax
Response/Action
Set
+MIPFLUSH = <Socket ID>
ERROR
or:
+MIPFLUSH: <Socket ID>
OK
Read
+MIPFLUSH?
+MIPFLUSH:[<socket ID>]
Test
+MIPFLUSH=?
+MIPFLUSH=(<Socket ID>)
Table 3-202: +MIPFLUSH Parameters
<Parameter>
Description
Socket ID
1,2,3,4 - Number of valid sockets