PIONEERPOS AT Commands G24-LC - Manual (Page 78)

Call Control
3-14 G24-L AT Commands Reference Manual April 15, 2008
atd>1; //Speed dial from phonebook
OK
OK
ath
NO CARRIER
OK
atd>1 //Speed dial from phonebook
+CME ERROR: //Invalid characters in dial string
atd>"Motorola Internal"
+CME ERROR: //Invalid characters in dial string
For more examples, refer to “Call Control” on page 4-14 and “Data Call” on page 4-18 .
DL, Dial Last Number
The DL command places a data/voice call to the last number dialed. The call progress
information (success/failure) is reported in the same way as for the Dial command. (
Refer to “D,
Dial Command”, page 3-11 ).
The following table shows the DL parameters.
Command Detailed Description
ATDL[;] Initial Response - Last Number retrieved:
ATDL: "DIAL DIGITS"
2nd response - Data/Fax call connected CONNECT
1st response - Voice call placement begins
OK
2nd response - Voice call connected OK
Table 3-6: DL Parameters
<Parameter> Description
semicolon (;) If the semicolon (;) is given, a voice call is originated to the last dialed number.
If the semicolon (;) is not given, a Fax/Data call is originated.
Note: The last dialed call type is irrelevant to the DL command.