Panasonic CQ-DP101W EN - Manual (Page 3)

E
N
G
L
I
S
H
2
CQ-DP151/DP101W
19
Power and Sound Controls E
N
G
L
I
S
H
1
CQ-DP151/DP101W
18
Remote Control Unit Preparation
Battery Installation
1 Remove the battery holder.
Pull the holder by the position B while pushing posi-
tion A in the direction indicated by the arrow.
2 Install the battery on the battery holder.
Set a new battery properly with its (i) side facing up
as shown in the figure.
3 Insert the battery holder.
Push in the battery holder back into its original posi-
tion.
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
≥
Battery type: Panasonic lithium battery (CR2025) (included)
≥ Battery life: Approximately 6 months with normal use (at room temperature)
Back side
Lithium battery
(included)
Battery holder Position A
Position B
≥ Do not disassemble or short the battery. Do not throw a battery into a fire.
≥ Keep batteries away from children to avoid the risk of accidents.
≥ Be careful to the local disposal rules when you dispose of batteries.
Control Reference Guide
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit’s sensor (REMOTE).
Mute button (MUTE)
(
➡ page 19)
Volume control buttons
(VOL,
" #)
( ➡ page 19)
Tune/ Track buttons
(TUNE/TRACK, 6 5/
% $)
( ➡ pages 22, 25)
Mode button (MODE)
(
➡ pages 22, 24)
Caution:
≥
Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
Band button (BAND)
(
➡ page 22)
PWR
MODE
PRG
TUNE
TRACK
Car Audio
BAND/DISC UP
VOL
MUTE
(ATT)
Power button (PWR)
(
➡ page 19)
Power
Turn the key in the ignition until the accessory indica-
tor lights.
Power on: Press [SOURCE] (PWR).
Power off: Press [SOURCE] (PWR) again and hold.
Mute
Press [MUTE] to mute the sound completely.
Press [MUTE] again to cancel.
Volume
[ " VOL]: Up
[ # VOL]: Down
Press and hold for rapid adjustment.
Volume level (0 to 40)
Anti-volume-blast circuit:
When the power is switched off and on again, the volume slowly rises to the previous level.
The anti-volume-blast circuit will not work when the volume level is set lower than position 20 on the dis-
play.
MUTE
< VOL
SEL
BAND
TUNE
MUTE M/L 1 2 3 4 5 6
7 12
SOURCE
REP
CQ-DP151W CD RECEIVER 45W X 4
LOUD
RANDOM
PWR
8 11 9 10
TRACK
DISP
MONO/LOC
REMOTE
SCAN/APM
Remote control signal sensor
Loudness
Press [LOUD] to enhance bass and treble
tones at low or medium volume.
Press [LOUD] again to cancel.
LOUD
ACC
ON
Note:
≥
Disc up button (DISC UP) cannot be used in this model.
Only for CQ-DP151W