Panasonic AG-HPX300P - Manual (Page 132)

1
Chapter

Men
uOper
ations
OUTPUT SEL screen
Item Setting Notes
SDI SELECT Sets the signal format type output from the SDI OUT
connector.
AUTO:
Depends on SYSTEM MODE setting.
1080i *1 : Outputs 1080-59.94i also when SYSTEM
MODE setting is 720-59.94P.
480i:
Output is locked to 480-59.94i regardless of
SYSTEM MODE setting.
• Not available when SYSTEM MODE is
set to 480-59.94i. Then 480i is output
at all times.
SDI METADATA Sets metadata (UMID) superimposition onto SDI OUT.
ON:
Superimposes metadata.
OFF: Does not superimpose metadata.
SDI EDH Sets EDH superimposition when SDI OUT is an SD
signal (480i).
ON:
Superimposes EDH.
OFF: Does not superimpose EDH.
DOWNCON MODE Sets downconverter output (VIDEO OUT and 480i SDI
OUT) in HD mode (1080i, 720P).
SIDE CROP, LETTER BOX, SQUEEZE • Not available when SYSTEM MODE is
set to 480-59.94i.
VIDEO OUT CHAR Specifies whether or not characters are superimposed
on VIDEO OUT signals.
ON:
Superimposes characters.
OFF: Does not superimpose characters.
• This setting is disabled when RC10
(remote controller) is connected
in which case RC10 settings have
priority.
VIDEO OUT ZEBRA Specifies whether or not zebra pattern is
superimposed on VIDEO OUT signals.
ON:
Displays a zebra pattern also on images output
via the VIDEO OUT connector.
OFF:
The zebra pattern is not displayed in video
output from the VIDEO OUT connector.
TC OUT Sets the time code type output from the TC OUT
connector.
TCG:
Outputs the time code generator value of the
camera at all times.
TCG/TCR:
Outputs time code generator value during
camera recording and outputs the played back time
code during video playback.
TC VIDEO SYNCRO Sets the delay of time code output from the TC OUT
connector.
TC IN:
Does not delay output of input to TC IN
connector.
VIDEO OUT:
Outputs the time code in line with delay
of video output from the VIDEO OUT connector.
*1 Use 1080i selected in a SYSTEM MODE setting of 720-59.94P for checking video.
DISPLAY SETUP screen
Item Setting Notes
EVF PEAK LEVEL Adjusts the peaking level of the viewfinder and the
LCD monitor.
–7 ... 0 ... 7
EVF PEAK FREQ Adjusts the peaking frequency of the viewfinder and
the LCD monitor.
HIGH, LOW
____ indicates the factory setting