Panasonic AG-HPX300P - Manual (Page 149)

1
Chapter

Maintenance
and
Inspections
Inspection for Using an External
Microphone
1
 ConnectanexternalmicrophonetotheREAR1
andREARconnectors.
2
 SettheAUDIOINswitchto[REAR].
3
 SettheLINE/MIC/+Vselectorswitcheson
therearpanelto[MIC]or[+V],depending
onthepowersupplytypeoftheexternal
microphone.
• MIC: For a microphone with internal power supply.
• +48V: For a microphone with external power
supply.
4
 Aimthemicrophoneatthesoundsourceand
checkthatthesoundlevelindicationintheLCD
orviewfindervarieswithchangesinsound
intensity.
• The channels can also be checked separately by
connecting a single microphone to each channel.
Inspection of the clock, time code, and
user bits
1
 Settheuserbitsasrequired.
Please refer to [Setting user bits] (page 58) for the
setting procedures.
2
 Setthetimecode.
Please refer to [Setting the Time Code] (page 60) for
the setting procedures.
3
 SettheTCGswitchtoR-RUN.
• Press the COUNTER button to display the time
code on the LCD monitor or in the viewfinder.
4
 PresstheRECbutton.
• Check that the counter display number changes
as recording progresses.
5
 PresstheRECbuttonagain.
• Check that recording stops and the counter
display number stops changing.
6
 SettheTCGswitchtoF-RUN.
• Check that the counter display number changes
regardless of recording status.
7
 HolddowntheDISP/MODECHKbuttonto
checkthedateandtimeontheLCDmonitoror
intheviewfinder.
• Adjust the date and time setting if the DATE, TIME
and time zone is not correctly displayed.
For details, see [Setting Date and Time of Internal
Clock] (page 26).
 NOTE
Note that date and time data set for DATE, TIME, and
time zone is recorded in clips, and affects the playback
sequence, etc. at the time of thumbnail manipulations.