Panasonic AG-HPX300P - Manual (Page 153)

1
Chapter

Maintenance
and
Inspections
Warning and Error Display for Thumbnail Operation and USB HOST MODE
Item Message Description Measure
Thumbnails
CANNOT ACCESS!
Data cannot be accessed because it is
corrupted or for other reasons. Restore media and clips to normal state
before access.
CANNOT CHANGE!
Any thumbnails that cannot be produced
on the AVC-Intra 100 or AVC-Intra 50 and
displayed in gray cannot be changed at the
text memo position.
Set SYSTEM MODE according to the clips.
CANNOT COPY! Images cannot be copied. Check the conditions for copying.
CANNOT DELETE !
P2 card contains contents version
mismatches or bad clips. Match devices and contents versions, and
repair bad clips.
CANNOT FORMAT! P2 card problem prevents formatting. Check P2 card.
CANNOT
RECONNECT! A clip that does not span multiple P2 cards
cannot be reconnected.
Check selected content.
CANNOT REPAIR!
Data cannot be repaired since content that
cannot be repaired is selected.
Check selected content.
CANNOT REPAIR IN
SELECTION! Some of the selected clip could not be
repaired.
—
CARD FULL! The P2 or SD card is full. Insert media with sufficient capacity.
INVALID VALUE! Entered data was invalid. Enter data in a valid range.
LACK OF REC
CAPACITY! There is not enough recording capacity left
on the card. Insert a card with sufficient recording
capacity.
MISSING CLIP!
A shot mark will be added to the clips
recorded on multiple P2 cards when all P2
cards are not inserted yet.
Insert all P2 cards with recorded clips,
and confirm that the ! incomplete clip
indicators disappear, and then add shot
marks.
NO CARD! No P2 or SD card is inserted. Insert compatible media.
NO COPY TO SAME
CARD! A clip cannot be copied to the card storing
the original clip. Copy the selected clip to a card that does
not contain the original clip.
NO FILE! The designated file is not found. Check the file.
NO SD CARD! No SD card is inserted. Insert an SD card.
SAME CLIP IS
SELECTED!
The clip cannot be copied because a clip
that has already been copied and the original
clip have been selected. Confirm the selected clip and release
either the source clip or the destination
clip and then execute the copy operation.
TOO MANY CLIPS! Too many clips are selected. Reduce the number of selected clips.
UNKNOWN
CONTENTS FORMAT! P2 card contains contents version
mismatches or corrupted content. Match devices and contents versions, and
repair bad clips.
UNKNOWN DATA! The metadata character code is invalid.
Use UTF-8 for the metadata character
code. Use the viewer to enter correct
characters.
USER CLIP NAME
MODIFIED! Characters in the clip name had to be
deleted in adding the counter value.
The user clip name plus the counter
value can only contain up to 100
bytes. Characters in the clip name are
automatically deleted when the total
exceeds 100bytes.
WRITE PROTECTED! The P2 or SD card is write protected. Insert write-enabled media.
Soft
keyboard
CANNOT CHANGE!
[PERSON] will be entered while the text
memo is not available.
Enter [TEXT] before entering [PERSON].
CANNOT SET! INVALID
VALUE!
The entered value is incorrect. Change the value.
(Continued on the next page)