Pioneer VSX-515-S/-K - Manual (Page 53)

The System Setup menu 07
53
En
English
Français
Deutsch
Nederlands
Italiano
Español
3 Confirm your selected setup option.
The test tones will start after you press ENTER .
4 Adjust the level of each channel using the
/ (cursor up/down) buttons.
If you selected T. TONE M. , use / (cursor
left/right) to switch speakers.
The T. TONE A. setup will output test tones in
the following order (depending on the speaker
setting):
Adjust the level of each speaker as the test
tone is emitted. 1
5 When you’re finished, press RETURN.
Tip
• You can change the channel levels at any
time by using EFFECT/CH SEL and +/– on
the remote control. You can set two
channel levels: one for
DVD 5.1 CH and
one for the listening modes.
Speaker Distance
For good sound depth and separation from
your system, you need to specify the distance
of your speakers from the listening position.
The receiver can then add the proper delay
needed for effective surround sound.
1 Select ‘SP DISTN.’ from the SP SETUP
menu.
2 Use / (cursor left/right) to choose the
speaker that you want then set the distance.
Use / (cursor up/down) to adjust the
distance of each speaker (in 0.1 meter
increments).
3 When you’re finished, press RETURN.
Note
1 • If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level
of each speaker to 75 dB SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
L C
SBR
RS R
LS SW SBL
VSX_815-915.book.fm 53 ページ ２００５年３月１日 火曜日 午前１０時２２分