Pioneer AVH-P7500DVD - Manual (Page 77)

3 Touch PANORAMA and then touch d to
turn the Panorama control on.
# To turn the Panorama control off, touch c.
4 Touch DIMENSION and then touch c or
d to adjust front/surround speaker bal-
ance.
Each time you touch c or d moves the sound
towards the front or the surrounds.
+3  3 is displayed as the front/surround
speaker balance moves from front to sur-
rounds.
5 Touch CENTER WIDTH and then touch c
or d to adjust the center image.
Each time you touch c or d gradually spreads
the center channel sound into the front left
and right speakers over a range 07.
3 is the default and its recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to LARGE (large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select SMALL (small).
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SMALL or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LARGE if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Touch A.MENU and AUDIO and then
touch Sound Setting.
2 Touch SP SET.
3 Touch the speaker to be adjusted.
4 Touch a or b to select the correct size
for the selected speaker.
Each time you touch a or b selects the size in
the following order:
OFF (off)SMALL (small)LARGE (large)
# You cannot select OFF, when the front speak-
ers have been selected.
# You can turn ON or OFF, when the subwoofer
has been selected.
Correcting the subwoofers phase
If trying to boost the bass output of the sub-
woofer doesnt do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofers output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Touch A.MENU and AUDIO and then
touch Sound Setting.
2 Touch SP SET.
3 Touch the subwoofer.
4 Touch a to turn subwoofer output on.
# To turn subwoofer output off, touch b.
5 Touch c or d to select the phase of sub-
woofer output.
Touch d to select normal phase and
NORMAL appears in the display. Touch c to
select reverse phase and REVERSE appears in
the display.
Audio Adjustments
En
77
Section
15
Audio
Adjustments