Practical guide to installation, Product service, Maintenance (replacement of lamp) continued – Panasonic FV-08VKML2 User Manual
Page 16: Practical guide to installation product service
A0809-0 08VKML220
MAINTENANCE
(REPLACEMENT OF LAMP) CONTINUED
II
PRACTICAL GUIDE TO INSTALLATION
PRODUCT SERVICE
PANASONIC CONSUMER ELECTRONICS COMPANY
PANASONIC CANADA INC.
1. Remove grille. (Squeeze mounting spring and pull
down) (Fig.21-1,21-2 of page 15)
2. Remove the 4 W night lamp. (Fig.26)
Proper insulate the area around the fan
to minimize building heat loss and gain.
(Fig. 28)
Proper insulate the area around the fan
to minimize building heat loss and gain.
(Fig. 28)
Four inch or six inch roof jack, wall cap,
or soffit vent with backdraft damper.
Caulk termination to duct.
Short piece of flexible duct
helps alignment and absorbs
sound. Clamps plus tape at
all flex joints.
2-3 ft straight run before elbow.
In attic installation,
caulk box to drywall.
Foil tape tightly covers all metal
duct joints (glue PVC joints).
Loose fill or batt insulation can be placed
directly over the fan housing in the attic.
Panasonic fans and fan/light combination
units do not create excessive heat that is
a common problem with recessed light
fixtures or some competitors' fan/light
combinations. Our efficient, cool-running
motors and our fluorescent lamps do not
create enough ambient heat to be subjected
to these limitations.
3. Change the fluorescent lamps (Panasonic FDS
18E27/4, 18W or FDS18E35/4, 18W or FDS18E42/4,
18W) or the 4W night lamp, connect the plug
connector
and replace the grille. (Fig.27)
II
Fig.26
Fig.27
Fig.28
Insulation.
Warning Concerning Removal of Covers.
Division of Panasonic Corporation of North America,
One Panasonic Way, Secaucus, NJ 07094
5770 Ambler Drive, Mississauga, ON L4W 2T3
The unit should be serviced by qualified technicians only. No service information is provided for customers.
Your product is designed and manufactured to ensure a minimum of maintenance. However, should your
unit ever require service, a nationwide system of factory service centers and AUTHORIZED INDEPENDENT
SERVICE CENTERS is maintained to support your product's warranty.
(In the U.S.A., Call 1-866-292-7292 to Customer call Center.)
PDF created with pdfFactory Pro trial versi