Pioneer VSX-D509S - Manual (Page 32)

32
Displays & Controls
Remote Control (VSX-D509S)
Î
SOURCE
ENTER
MIDNIGHT
SIGNAL SELECT
TV CONTROL
TV VOL TVFUNC
TV
MENU
ENTER
D.ACCESS BAND CLASS
CH SELECT CH LEVEL
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
DSP TEST TONE
FL DIMMER
LOUDNESS FUNCTION SETUP MUTING
MPX DTV ON / OFF DTV MENU
FQ
FQ
ST ST
CHANNEL
EFFECT
MASTER VOLUME
DISC +10
5.1CH
MULTI CONTROL
ATT
DVD TV VCR CD-R
RCV CD TUN TVC
RECEIVER
1 2 3
4 5 6
7 8 9
7
4 ¢
3 1 ¡
0
8
2
1
=
~
!
@
8
9
0
3
4
6
2
-
7
_
¡
$
™
£
%
*
(
)
^
&
+
#
5
1 SOURCE button
Use to turn on/off other components coneccted
to the receiver.
2 MULTI CONTROL buttons
Use to put the receiver/remote control in the
stated mode.
For other equipment controls, see Controlling
the Rest of Your System on pages 46-50.
3 NUMBER/MODE buttons (see pages
23, 43)
Use the number buttons to select the radio
frequency in tuner DIRECT ACCESS mode or
the tracks in CD, DVD mode etc.
Also, buttons marked with the following names
have special functions. If you try to use one of
these functions but the display flashes it means
that function cannot be used in the current mode
(for example DSP modes cannot be used when
5.1 CH setting is on).
MIDNIGHT (see page 40)
Use to put receiver in MIDNIGHT mode. To use
first press the RECEIVER button then operate
this button.
5.1 CH (see page 39)
When the DVD/LD or DVD 5.1 CH function is
selected each press switches the DVD/LD input
between DVD/LD and DVD 5.1 CH. To use first
press the RECEIVER button then operate this
button.
ATT
Use to attenunate (lower) the level of an analog
input signal and prevent distortion (refer to p.31
=). To use first press the RECEIVER button
then operate this button.
SIGNAL SELECT (see page 37)
Use to select the proper signal (analog, digital) for
the source your are inputting. To use first press
the RECEIVER button then operate this button.
EFFECT +/– buttons
Use to add or subtract the amount of effect in
different DSP sound modes or advanced
listening modes.