Panasonic 35 - Manual (Page 22)

Getting started
12
5.4
Connecting the AC adapter
Plug the connector of the supplied AC adapter into the AC adapter connector on
the rear panel. To ensure that the controller is completely disconnected from t
he power supply, unplug this connector.
Only connect the power plug end of the AC adapter to a power socket after
the controller is fully set up.
The supplied power cable is a 100 V (AC) cable for use in Japan.
5.5
Power-on operation
To start up the controller, insert the supplied power key into the power key switch
and turn it clockwise.
When the power is turned on a beep will sound and the display will indicate
startup status. The display will then change to operation mode (under the default
setting).
Warning Warning Warning Warning