Panasonic SCPM19 - Manual (Page 21)

Recording operations
21
RQT7369
Before recording
• Only normal position tapes are recommended.
• Volume and sound quality during playback have no effect on
recording.
Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
To erase a recorded sound
1 Press [TAPE 3] and then [STOP 7, –DEMO].
2 Insert the recorded cassette with the tape facing out.
3 Press [¶/8 REC].
Your attention is drawn to the fact that recording pre-
recorded tapes or discs or other published or broadcast
material may infringe copyright laws.
Preparatory steps
Wind up the leader tape to begin recording immediately.
Preparation: Press [TAPE
3] and then [STOP 7, –DEMO] to
select tape as the source.
Press [OPEN 0], insert a cassette with the tape
facing out.
Close the lid by hand.
A Recording the radio
Preparation: Do the preparatory steps as above.
1
Tune to the required station.
( \ page 9)
2
Press [ ¶/8 REC] to start recording.
Side A
Tab for side B Tab for side A
To re-record
Adhesive tape
Normal tape
OPEN 0
B
Insert inside the
guides
Forward side
B
A
2
DEMO
STOP ,
2
¶ / 8
REC
To
stop recording
stop recording
temporarily
cut an unnecessary
part while recording
record on the other
side of the tape
Action
Press [STOP
7
, –DEMO].
Press [
¶/8
REC].
Press [
¶/8
REC] again to resume
recording.
Press [
¶/8
REC] during the
unnecessary part.
Press [
¶/8
REC] again to resume
recording.
Turn the tape over and press [
¶/8
REC].
RQT7369-B_21-22_EN 19/1/04, 7:19 pm 21