Pioneer DV-656A - Manual (Page 9)

Before You Start 01
9
En
Incorrect use of batteries can result in
hazards such as leakage and bursting.
Please observe the following:
• Don’t mix new and old batteries
together.
• Don’t use different kinds of battery
together—although they may look
similar, different batteries may have
different voltages.
• Make sure that the plus and minus ends
of each battery match the indications in
the battery compartment.
• Remove batteries from equipment that
isn’t going to be used for a month or
more.
• When disposing of used batteries,
please comply with governmental
regulations or environmental public
instruction’s rules that apply in your
country or area.
Using the remote control
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote
sensor on the unit.
• The remote has a range of about 23 ft.
(7 meters)
• Remote operation may become unreli-
able if strong sunlight or fluorescent
light is shining on the unit’s remote
sensor.
• Remote controllers for different devices
can interfere with each other. Avoid
using remotes for other equipment
located close to this unit.
• Replace the batteries when you notice a
fall off in the operating range of the
remote.
What’s in the box
Please confirm that the following accesso-
ries are in the box when you open it.
• Remote control
• AA/R6P dry cell batteries x2
• Stereo audio cable (red/white plugs)
• Video cable (yellow plugs)
• Power cable
• These operating instructions
• Warranty card (DV-656A and DV-655 px
model only)
Putting the batteries in the
remote control
1 Open the battery compartment cover
on the back of the remote control.
2 Insert two AA/R6P batteries into the
battery compartment following the
indications (
ª, ·) inside the compart-
ment.
3 Close the cover.