Panasonic RX-D29 - Manual (Page 7)

RQTT0585
7
Listening to CDs
Normal play Program play
1 2 3 4
1
2
3
1 Push [ CD OPEN/CLOSE] to
open the CD lid and insert the CD.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
2 Push [ CD OPEN/CLOSE] to
close the CD lid.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3 Press [CD / ] to start play.
(Unit comes on.)
Play starts from the first track and
continues to the last track.
RX-D29 only
When playing MP3, “MP3” is displayed.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4 Adjust the volume.
To stop play
Press [ ].
While stopped, the number of tracks on the CD is displayed.
Remote control only
Ensure CD is stopped before programming.
1 Press [PGM/CLEAR].
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
2 Enter the track number with the numbered buttons.
To select a two digit number
e.g.16: [ = 10] → [1] → [6] >
To select a three digit number (MP3 only)
e.g.226: [ = 10] → [
= 10] → [2] → [2] → [6] > >
Repeat step 2 until you have programmed all the tracks you want.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3 Press [CD / ] .
To cancel program play mode
Press [PGM/CLEAR] while stopped. “CLEAR” is displayed.
The mode is also canceled if the CD tray is opened.
This will also erase the entire program.
To check program contents
“P” appears in the display when play is stopped.
Press [–/
] or [ /+] when “P” is displayed.
To check while programming press [DISPLAY] twice and after “P” appears,
press [–/
] or [ /+].
Display
“— —:— —”:
Program equals, or exceeds, 100 minutes but
programming and play are still possible.
“FULL”: 24 tracks have already been programmed. The program is full.
Label must face upward.
Elapsed play time
Track number in play
Total playing time
Total number of tracks
(MP3 only)
Total number of tracks
Total number of albums
CD play modes
Remote control only
You can repeat one track ( ), all tracks ( ) or play the tracks in
random order ( ).
Press [PLAY MODE] before or during playback to select the
desired mode.
off (no indication)
RX-D29 only
When playing MP3, see page 8.
These modes remain active until the indicators are cleared.
You can use repeat mode with program play.
Note
• During play, you cannot select random play.
• Random and program play cannot be performed at the same time.
To pause
To search forward/
backward
To skip forward/
backward
Press [CD / ] during playback.
To resume, press [CD / ].
Hold down [ −/ ] (backward) or [ /+] (forward)
during playback or when paused.
You cannot search while playing MP3.
Press [ −/ ] (backward) or [ /+] (forward)
during playback or when paused.
You can program up to 24 tracks.
Display
“NO DISC” is displayed if there is no disc in the unit.
Note
• If interference occurs to radios or televisions, place the unit as far as
possible from the equipment.
• Do not push [ CD OPEN/CLOSE] during play, pause or immediately
after you inserted the CD and closed the CD lid. CD may be scratched.
This unit can play CD-DA (digital audio) format audio CD-R and CD-
RW that have been finalized (a process that enables CD-R/CD-RW
players to play audio CD-R and CD-RW) upon completion of recording.
It may not be able to play some CD-R or CD-RW due to the condition
of the recording.
Program order
Specified track number
Total play time of programmed tracks
(MP3 only)
Program order
Specified track number