Recording, Setting the time – Panasonic RX-D29 User Manual

Page 9

Advertising
background image

RQTT0585

9

Recording

You can record radio broadcasts or CDs.
Before recording
• This unit is suitable for recording normal tapes, but it cannot record

onto high and metal position tapes to their full potential and prior
recordings will not be erased correctly.

• The recording level is set automatically.
• Take up the leader tape before proceeding.

1

Press [

/

STOP/EJECT ] to

open the deck and load a cassette.

Close deck by hand.

2

Select the source to be recorded.

When recording radio broadcasts
Tune in the station. (Perform steps 1–3 of “Normal tuning” on page 6.)
When recording CDs
Insert the CD to be recorded.
(Perform steps 1 and 2 of “Normal play” on page 7.)
Press [CD / ] and then [ ] to switch to CD mode.

If you want to record programmed tracks, program desired tracks
before proceeding to step 3.

3

Press [

] to start recording.

[ PLAY ] is also depressed with [

].

Recording starts (one side only).
The CD also starts playing if in CD mode.

1 3

Leader tape (Recording cannot be made.)

Exposed tape facing
upward

Side to be recorded
facing you

To stop recording
Press [ / STOP/EJECT ]. (The CD does not stop.)

To stop recording temporarily
Press [ PAUSE ]. (The CD does not stop.)
Press once again to resume recording.

To record on the other side of the cassette
Turn the cassette over and press [

].

If the CD finishes before the cassette
Recording continues. Press [ / STOP/EJECT ] to stop it.

If the cassette finishes before the CD
The CD continues playing. Press [ ] to stop it.

Erase protection
Use a screwdriver or similar object
to break out the tab.

To re-record on a protected cassette
Cover the hole with adhesive tape.

To erase a tape
1. Press [TAPE/OFF].
2. Insert the cassette with the side to be erased facing towards you and

the exposed tape facing up.

3. Press [

].

[ PLAY ] is depressed at the same time.

Note

• Noise may be recorded if this unit is near a TV. Keep the units at least

1.5 meters apart.

• Changes to volume and sound quality do not affect recording.
• To prevent interruptions to recording, make sure there is constant AC

power supply to the unit or replace the batteries.

• While recording you cannot perform the following operations.

- Switching play of the source (CD, Radio, Tape)
- Switching the radio AM/FM frequency
- CD skipping, searching

Setting the time

This is a 12-hour clock.

1

Press [TUNER/BAND –AUTO PRESET] to turn the unit on.

You can also use [CD / ], [ PLAY] to turn the unit on.

Remote control only

2

Press [CLOCK/TIMER ADJ] once.

3

Within 10 seconds
Press [– /

] or [

/ +] to set the

time.

Press and hold to change the time faster.

Remote control only

4

Press [CLOCK/TIMER ADJ].

To switch to clock display
Press [DISPLAY].
Clock display

←→ Current display

Displaying the clock temporarily
Press [CLOCK/TIMER ADJ].
The clock is shown for about 10 seconds.

Note

The clock is accurate to within

± 60 seconds a month.

Readjust if necessary.

1

3

2 · 4

Tab for side A

Tab for side B

Adhesive tape

Side A

Advertising
This manual is related to the following products: