Philips CD6452B - Manual (Page 39)

37 Frequently asked questions
EN
GLI
SH
10 Frequently asked questions
www.philips.com/support
In this chapter you will find the most frequently
asked questions and answers about your phone.
Connection
The handset does not switch on!
• Charge the battery: Put the handset on
charger. After a few moments the phone will
switch on.
• Check the charger connections
• Use only the SUPPLIED
RECHARGEABLE BATTERIES.
The phone does not work at all.
• Make sure that the adaptor and the phone cord
are connected properly
• Check that the batteries are fully charged and
installed properly
• This phone does not work during power failure
Communication is lost during a call!
• Charge the battery
• Move closer to the base station
Poor audio quality
• Move closer to the base station
• Move the base station at least one meter away
from any electrical appliances
No dialing tone
• Check the connections. Reset the phone:
unplug and plug back in the mains.
• Charge the batteries for at least 24 hours
• Move closer to the base station
• Use the line cable provided
• Connect the line adaptor (when needed) to the
line cord
The is blinking.
• Move closer to the base station
• Check battery level
• Register the handset to the base station
The appears soon after the batteries
are charged.
• Replace the batteries with new ones (use only
RECHARGEABLE batteries)
Set-up
Caller ID does not work properly.
• Check with your local phone company that the
CID service is subscribed to
• Let the phone ring at least once before
answering
The Call Waiting call cannot be answered.
• Check with your local phone company and
select the correct recall duration
The handset LCD displays nothing.
• Try again by disconnecting and connecting the
base station power supply and follow the
procedure to register a handset (see Section
5.8.6)
• Make sure the two supplied rechargeable
batteries have been inserted properly into the
battery compartment
• Remove and place back the handset batteries
• Make sure the supplied batteries are charged
up
The handset displays Unregistered.
• Follow the procedures to register the handset
to a base
Sound
Handset does not ring!
• Increase the volume
• Make sure that the adaptor and the phone cord
are connected properly
• Move the handset closer to the base unit
• Make sure the handset ringer is turned on
CD645_IFU_US_English.book Page 37 Friday, August 3, 2007 5:10 PM