Powering up the system, Powering up the system -10 – Polycom DOC2232A User Manual
Page 24
Advertising
MGC-25 Getting Started Guide
2-10
Powering Up the System
1.
Make sure the power cable is connected to the system and to a grounded
power outlet.
2.
Press the power switch to “
1” to start the system.
On the front panel of the MGC-25 the power indicator LED and the LCD
Display Window flash. The system startup may take up to five minutes.
Wait at least 10 seconds between turning the system off and turning it on. If you
turn the system off and then try to turn it on right away, the system will not allow
powering up for one minute.
Advertising
This manual is related to the following products: