PYLE Audio Power Inverter PNVU500 User Manual

Owner’s manual power inverter

Advertising
background image

Three-prong AC

Receptacle

LED

OWNER’S MANUAL

POWER INVERTER

www.pyleaudio.com

1

2

3

4

5

6

-FEATURES

Specification are typical; individual units might vary.

Specifications are subject to change and improvement without notice.

INTRODUCTION

Thank you for purchasing the Pyle view Inverter . The Pyle view Inverter will power a wide variety of

household or electronic appliance reliably from the 12V volt in your vehicle or boat ,or directly from a

12volt battery to serve . Such as laptop computers, digital /video camera , Mp3 player ,cell phones

,Ipod TM, Blackberry TM and etc.

Please pay your special attention to all CAUTION and WARNING statements. Improper use of this

inverter can cause personnel injury, property damage

-WARNING

•Shock Hazard. Keep away from children.

•The PNVU500 Generates the same potentially lethal AC power as normal household wall outlet.

Treat it with the same respect that You would do to any AC outlet.

•The PNVU500 is designed for indoor use only and not recommended for use with inductive loads,

such as florescent lamps, compressors & pumps.

•Ensure to maintain at least 2-inch (5cm) air space on all sides of this inverter, as its housing may

became uncomfortably warm, reaching 140 F (60 C) under extended high power.

•Disconnect power to the inverter when it is not in use.

•Do not expose this inverter to water, rain, snow or spray.

•Do not insert foreign objects into this inverter’s AC outlets.

•Do not leave this inverter or any device operating unattended, to avoid property damage potentially.

•Do not use or place this inverter near flammable materials or any places, which accumulate

flammable fumes.

•Do not connect this inverter to power utility AC distribution wiring under any circumstance.

•Check the input and output connectors of this inverter are tight regularly. The loose connections can

generate harmful heat and /of damage the inverter or power source.

-CAUTION

•Do not connect any AC product to this inverter, whose neutral conductor is connected to ground.

•Do not expose this inverter temperature in excess of 100 F(40 C).

•This inverter must be connected only to batteries with a normal output voltage of 12 Volts. This unit

will not operate from a 6-Volt battery and will be damaged if it is connected to a 24-Volt battery.

12V DC Input

USB Port

Vehicel power plug

Airplane power plug

OPERATION

-CAUTION: DO NOT USE THIS INVERTER WITH THE FOLLOWING:

•Small battery operated appliances such as RECHARGEABLE FLASHLIGHTS, SOME

RECHARGEABLE SHAVERS and NIGHT LIGHTS that are plugged directly into as RECEPTACLE

TO RECHARGE.

•BATTERY CHARGES used with certain power tool battery packs. These chargers will have a

WARNING LABEL stating that DANGEROUS VOLTAGE ARE PRESENT AT THE CHARGERS

BATTERY TERMINALS.

-WARNING:

Batteries contain corrosive materials and present an Energy Hazard. To prevent irritation and

burns, wear protective wear and clothing, and take special care to ensure no metal tools or

personal objects contact the battery terminals.

Using the inverter

Using the Power cord with cigarette lighter plug

A: Connect the cigarette lighter plug adapter to power cord .

B .Plug the power cord into the power cord port on pyle view inverter

C: Insert the cigarette lighter plug into the 12V outlet

D. Plug an AC product into the three-prong AC receptacle and the led lights blue.

Caution :

Ensure your product draws 120watts or less of continuous AC power. To avoid discharging the

vehicle battery, always remove the inverter from the lighter socket when not in use.

Using the power cord with airplane power plug

A .Plug the power cord into the power cord port on pyle view inverter

B: Insert the airplane power plug into the 12V outlet

D. Plug an AC product into the three-prong AC receptacle and the led lights blue.

Caution :

Ensure your product draws 120watts or less of continuous AC power. To avoid discharging the

vehicle battery, always remove the inverter from the lighter socket when not in use.

Inverter operation

1. When properly connected to a 12V outlet , the light will turn blue , indicating the inverter is ready

2 . Plug the AC product into the AC outlet or USB port .

-The LED indicators---- dual-light LED

A. GREEN: It indicates the inverter is power on,

B. . RED : It indicates the inverter shutdown caused by low voltage, overload, or excessive tempera-

ture.


CAUTION:

•Do not connect to AC DISTRIBUTION WIRING. The inverter is designed for connection directly to

standard electrical and electronic equipment.

•Do not connect the inverter to household or RV AC distribution wiring.

•Do not connect the inverter to any AC load circuit in which the neutral conductor is connected to

ground (earth) or to the negative of DC (battery) source.

BATTERY OPERATING TIME

The vehicle batteries are not intended for constant deep discharge, they are designed to provide

brief periods of very high current needed for engine starting. It is strongly recommended to start the

vehicle every hour or two to recharge battery before its capacity drops too low. Operating the inverter

from a vehicle battery until the low voltage shutdown will shorten the battery’s life.

The inverter can operate whether or not the vehicle’s engine is running, but the normal voltage drop

that occurs during starting may trigger the inverter’s low voltage shutdown feature.

The use of a deep discharge battery is strongly advised for longer operating times. Its capacity

should be selected based on the desired operating time.

PROTECTION

SYMPTOMS PROTECTION

The low voltage battery (bel0w DC 10V) The unit auto shutdown.

The LED turns red .

The high input voltage (over DC 15.6V) The unit auto shutdown

The overload The LED turns red .

The overheat

Troubleshooting

SYMPTOM A: NO AC POWER OUTPUT , THE GREEN TURNS OFF

POSSIBLE CAUSE

SUGGESTION

AC product connected is rated at more than
120watts; overload shutdown occurs

Use product with a power rating of less than
120watts

Peak power has caused overload shutdown even
though AC product connected is rated at less than
120 watts

Product exceeds inverter’s surge capability. Use a
product with peak power of less than 240W

Lighter socket or 12 volt outlet may require ignition
to be switched on

Turn ignition key to accessory position

Poor contact with lighter socket or 12 volt outlet

Press inverter firmly into the lighter socket. Make

sure socket is clean.

Vehicle battery is discharged

Recharge battery

Problem: Buzzing sound in audio systems

Inexpensive stereo systems have an inadequate internal power supply filtering which causes a

buzzing sound. A system with a high quality filter is the only solution.

SPECIFICATIONS

AC Power Output

AC output voltage (nominal)……………………………………..115 Volts AC

DC input voltage range…..………………………………………10-15 Volts DC

Maximum Continuous AC output power………………………..240 Watts

Maximum AC output surge power……………………………….120 Watts

AC output frequency……………………………………...………60 HZ +/- 2 HZ

AC output waveform…………………………………………...….modified sine wave

NO load current draw………………………………………...……less than 0.3A

Input current …………………………………………………...…..12.8-20 AMP

Optimum efficiency…………………………………………...……90%

Ambient operating temperature range……………………...……0 C-40 C/32 C-100 C

Low battery shut down point (nominal)…………………..………9.7-10.3 Volts

High battery shut down point (nominal)………………….………15-16 Volts

AC receptacles……………………………………………….……..1

DC receptacles……………………………………………….……..1

.Dimensions (W x H x D mm)………………………………………121x53x282 (PINV4)

USB Power Output

DC output voltage ………………………………………………….5V

DC output current (max )…………………………………………..0.5A DC

Remarks: The USB port doesn’t provide the data exchange . It only powers the an external USB-

powered device .

Advertising