Pioneer RMF-V4011R - Manual (Page 120)

119
ADJUSTMENTS
4 Precautions Upon Use (Adjustment Control Unit)
• Always release the adjustment mode with ADJ OUT button and turn off the power with the POWER button after adjust-
ments and settings. All adjusted values and settings will be memorized.
• The remote control adjustment mode will automatically be exited in the following.
1. When no operations are performed for about 180 seconds.
2. When the rear panel switch is pressed
3. When the power is turned off
4. When the input signal is switched, the cable is disconnected, or the mode is switched : NTSC PAL.
(However, in some cases, switching between PAL and no-signal may not exit the mode.)
• One multi-projection unit cannot be adjusted using the remote control unit and personal computer simultaneously. If using
the remote control unit after the personal computer adjustment mode has been started up, start up the remote control unit
adjustment mode or turn off the power once.
• When operating several multi-projection units simultaneously, do not press the buttons quickly and continuously as some
units may not synchronize with the other units.
• Multi-projection units not assigned an ID cannot be operated using the remote control unit. To exit this state, perform one
of the following.
1. Start up the remote control adjustment mode using the
ADJ IN
button.
2. Exit the remote control adjustment mode using the ADJ OUT button.
3. Turn off the power.
• The remote control signal is output to the next unit via the link terminal only when a certain ID is set to the multi projection
units. When operating several units, set this ID to all the units. Only units connected with the link cable located after the units
to which the remote control unit is connected can be operated.
• Up to 16 units can be operated using the remote control at one time using the link cable. To operate more than 16 units, use
a personal computer as well or reconnect the remote control.
• Handle the wire carefully.
Warning for Use of Dry Batteries
7 Using dry batteries incorrectly will result in battery liquid leakage, damage, etc. Take note of the following. (Also refer
to precautions provided for dry batteries.)
• Load the ª and · sides of the batteries correctly as shown on the battery case.
• Do not use old and new batteries together.
• Batteries of the same shape may have different voltages.
Do not use different batteries together.
• When not using the unit for a long period of time (one month), remove the batteries to prevent battery liquid leakage.
If leakage occurs, wipe the liquid thoroughly and load new batteries.
• Do not charge, short-circuit, disassemble, nor throw into fire the dry batteries provided.