Planet Technology GRT-101 - Manual (Page 44)

PLANET Technology Corp. GRT-101/401 User ’s Manual
- - 39
3.4.7 Reboot
To reboot GRT-101/GRT-401, use reboot command. Move cursor to “ >> “ to
write and press enter.
---------------------------------------------------------------------
Command: reboot <CR>
Message: Please input the following information.
Do you want to reboot? (y/n): y
---------------------------------------------------------------------
3.4.8 Ping
Ping command will be used to test the connection of router. Move cursor
“ >>
“ to ping and press enter.
---------------------------------------------------------------------
Command: ping <ip> [1~65534|-t] [1~1999]
Message: Please input the following information.
IP address <IP> : 10.0.0.1
Number of ping request packets to send (TAB select): 1~65534
Data size [1~1999]: 32
---------------------------------------------------------------------
3.5 Administration
You can modify the user profile, telnet access, SNMP (Simple Network
Management Protocol), supervisor information and SNTP (Simple Network
Time Protocol) in machine enable mode.
For configuration the parameters, move the cursor
“ >> “ to admin and press
enter.
>> user Manage user profile
security Setup system security
snmp Configure SNMP parameter
passwd Change supervisor password
Id Change supervisor ID
sntp Configure time synchronization
3.5.1 User Profile
You can use user command to clear, modify and list the user profile. You can
setup at most five users to access GRT-101/GRT-401 via console port or