Planet Technology GRT-101 - Manual (Page 53)

PLANET Technology Corp. GRT-101/401 User ’s Manual
- - 48
<Interface Operation>
LAN 1(Forward) WAN 1( Filter) WAN 2( Filter) WAN 3( Filter)
WAN 4( Filter) WAN 5( Filter) WAN 6( Filter) WAN 7( Filter)
WAN 8( Filter)
To modify the first entry in the table, use the “modify” command:
admin# setup bridge static modify 1 mac 00:30:4f:00:00:01
admin# setup bridge static modify 1 lan_port filter
admin# setup bridge static modify 1 wan1_port forward
To delete the first entry of the table, use the
“delete” command:
admin# setup bridge static delete 1
To save your changes, enter:
admin# write
3.11 Routing Mode
Note: This section is for routing mode operation only.
Routing is often confused with bridging, which performs a similar function. The
principal difference is that bridging occurs at a lower level (MAC layer)
whereas routing occurs at a higher level, e.g., IP layer. And because routing
occurs at a higher level, it can perform more complex analysis to determine the
optimal path for the packet.
GRT-101/GRT-401 supports IP routing, which can be static and/or RIPv1/v2
updating. Also, several applications, such as NAT/PAT, DHCP server, and DNS
proxy, etc., are included for LAN management and control.
3.11.1 LAN setting
To setup GRT-101/GRT-401 LAN interface with IP address of 192.168.0.1 and
subnet mask of 255.255.255.0, use the following command:
admin# setup lan 1 address 192.168.0.1 255.255.255.0
To save your changes, enter:
admin# write