Direct transmission, Manual number dialling (direct transmission), Basic operations – Panasonic AS200 User Manual
Page 49: Sending documents
BASIC OPERATIONS
BA
S
IC
OP
E
RATI
O
NS
47
Direct Transmission
If your machine's memory is full or you wish to send the document immediately, use Direct Transmission.
Manual Number Dialling (Direct Transmission)
To dial the telephone number manually, follow the steps below.
(see Note 1) (see Note 2) (see Note 3)
Make sure that the FAX lamp is ON. If not, press
to select the "FAX MODE".
1
a
Place original(s) face up on the ADF.
or
1
b
Place a book or an original face down on the
Platen Glass.
2
Make sure that the lamp goes off.
3
Enter a telephone number from the keypad.
Ex:
4
Your machine starts to dial the telephone number.
NOTE
1. If you need a special access number to get an outside line, dial it first then press
to enter a pause
(represented by a "-") before dialling the full number.
Ex
: 9 PAUSE 5551234
2. To stop the transmission, press
.
The display shows:
Press
to stop the transmission. The Communication Journal will not print out regardless of the printout mode
setting of the Communication Journal.
3. This field (AUTO, Line-1 or Line-2) appears only when the 2nd G3 Fax Communication Port Kit is installed.
ENTER STATION(S)
THEN PRESS START 00%
ENTER STATION
THEN PRESS START 00%
5
5
5
1
2
3
4
TEL NO. (AUTO)
5551234
❚
* DIALLING *
5551234
PAUSE
STOP
COMMUNICATION STOP?
1:YES 2:NO
1
Sending Documents
Note3