Remote control unit preparation, Troubleshooting, Remote control unit preparation troubleshooting – Panasonic DPX153U User Manual

Page 9: Power, Preliminary steps, If you suspect something wrong, Troubleshooting tips, Battery installation, Control reference guide, Common

Advertising
background image

POWER

MUTE

7

8

9

1

2

3

APM

BA

N

D

SRC

VO

LUM

E PUSH SE

L

[PWR]

(Power)

[MODE]

(Mode (source))
(

pages 12, 14)

Preliminary Steps

Check and take steps as described in the tables below.

If You Suspect Something Wrong

Immediately switch the power off.
Disconnect the power connector and check that there is nei-
ther smoke nor heat from the unit before asking for repairs.
Never try to repair the unit by yourself because it is dangerous
to do so.

No power.

Trouble

Car’s ignition switch is not on.

Turn your car’s ignition switch to ACC or ON.

Troubleshooting Tips

Common

Cables are not correctly connected.

Connect cables correctly.

Battery cable is not correctly connected.

Connect the battery cable to the terminal that is always active.

Accessory cable is not correctly connected.

Connect the accessory cable to your car’s ACC source.

Grounding wire is not correctly connected.

Connect the grounding wire to a metal part of the car.

Fuse is burnt out.

Call the store where you purchased the unit, or your nearest
Servicenter (see the attached sheet) and ask for fuse replacement.

No sound.

Mute is set to ON.

Set it to OFF.

Cables are not correctly connected.

Connect cables correctly.

Condensation (dew).

Wait for a while before use.

Cautions:

• Do not use the unit if it malfunctions or if

there is something wrong.

• Do not use the unit in irregular condi-

tion, for example, without sound, or with
smoke or foul smell, which can cause ig-
nition or electric shock. Immediately
stop using it and call the store where
you purchased it.

Cause/Step

A mobile phone is used near the unit.

Keep the mobile phone away from the unit.

Noise.

E
N

G

L

I

S
H

7

E
N

G

L

I

S
H

8

16

17

Remote Control Unit Preparation

Troubleshooting

CQ-DP133U/DP103U/DPX153U

CQ-DP133U/DP103U/DPX153U

Battery Installation

Remove the battery holder.

Pull the battery holder by the position B while push-
ing position A in the direction indicated by the arrow.

Install the battery on the battery holder.

Place a battery in the holder with its “+” side facing
up as shown in the figure.

Insert the battery holder.

Push the battery holder back into its original position.

Battery Notes

Remove and dispose of an old battery immediately.
Battery Information:
• Battery type: Panasonic lithium battery (CR2025) (included)
• Battery life:

Approximately 6 months with normal use (at room temperature)

Back side

Lithium battery
(included)

Battery holder

Position A

Position B

• Do not disassemble or short the battery. Do not throw a battery into a fire.
• Keep batteries away from children to avoid the risk of accidents.
• Be careful to observe proper local disposal rules when you dispose of batteries.

Control Reference Guide

Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit’s sensor.

[MUTE]

(Mute)
(

page 10)

[VOL] [

j

] [

i

]

(Volume )
(

page 10)

[TUNE] [TRACK] [

k

] [

l

] [

̇̇

] [

̈̈

]

(Tune/track selection/track search)
(

pages 12, 15)

Caution: Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a
fire. Battery leakage may damage the unit.

PWR

MODE

PRG

TUNE

TRACK

Car Audio

BAND/DISC UP

VOL

MUTE

(ATT)

Only for CQ-DP133U/CQ-DPX153U

[BAND]

(Band)
(

page 12)

Advertising
This manual is related to the following products: