5 configuring sync master, Figure 75, Configuration tool: sync master tab – Polycom KIRK 14117800 User Manual
Page 136
136
Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
For more information about saving the configuration, refer to
7.8.5 Configuring Sync Master
This section describes how to configure a Sync Master KWS600v3 in a multi-cell solution.
KWS600v3 primary and secondaries uses the existing DECT air interface to synchronize
to each other. One KWS600v3 is configured as a Sync (synchronization) Master in the
system. It is not necessary to configure what KWS600v3 the Sync Master should
synchronize to.
In the Sync Master tab you configure the Sync Master.
Figure 75
Configuration Tool: Sync Master tab
1
In the IP Address area:
• Deselect the DHCP check box.
First time you power up the KWS600v3 it acts as a DHCP client. To assign a
specific IP address to the unit, it is necessary to disable the DHCP mode.
• In the IP Address field, type the IP address of the Sync Master, provided by your
system administrator.
This IP address is now the default address when accessing the Sync Master.
• In the Network Mask field, type the network mask.
• In the Default Gateway field, type the IP address of the gateway.