2 set up of the hardware for repeater programming, Set up of the hardware for repeater programming, Programming the kirk repeater with the servicetool – Polycom KIRK 14117800 User Manual
Page 55
Note
For programming the repeater you also need the programming software
(ServiceTool) and the power supply for the repeater. The ServiceTool is
not part of the Programming Kit Repeater but can be downloaded from
www.polycom.com. The power supply for the repeater is to be ordered
separately (Part no. UK version: 84642421, Part no. EU version:
84642420, Part no. US version: 84642432).
Installing the KIRK Repeater 55
KIRK Wireless Server 600v3 Installation and Configuration Guide
Figure 5-4
Programming Kit Repeater
Splitter
Serial cable
5.4.2 Set up of the Hardware for Repeater Programming
1
Unplug the repeater power supply and insert the splitter.
2
Connect the repeater power supply to the splitter and the mains. LED flashes.
Note: Ensure that you have the appropriate power supply for the local requirements.
3
Connect the serial cable to the splitter and Com port of your computer.
The repeater is now ready for programming via the ServiceTool.
Note: The above mentioned order of the set up (point 1, 2 and 3) is important.
5.4.3 Programming the KIRK Repeater with the ServiceTool
The ServiceTool is the tool you access from your desktop and use for repeater
programming, handset adjustment and software download to the handset and repeater.
The ServiceTool identifies the type of repeater, and with this software it is possible to
program the KIRK Repeater to connect to the KIRK DECT Radio Infrastructure solutions.