Panasonic KX-TG6700 - Manual (Page 39)

Programming
For assistance, please visit http://www.panasonic.com/phonehelp 39
*1 If you program these settings using one of the handsets, you do not need to program
the same item using another handset.
*2 If you set the line selection mode from “Auto” to “Line1” or “Line2” (page 20), the
auto talk feature will function for that line only. If the other line receives a call, the auto
talk feature does not function.
*3 If you subscribe to Caller ID service and want to view the caller’s information after lifting
up the handset to answer a call, turn off this feature.
*4 This tone lets you know when you receive a call while you are on the other line, on an
intercom call, or monitoring a room. If you select “On”, the tone sounds repeatedly for
as long as the line rings. If you select “2”, the tone only sounds 2 times.
*5 Turn this feature off if you prefer not to hear key tones while you are dialing or pressing
any keys, including confirmation tones and error tones.
*6 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone
(tone 1 to 4). If you select a melody, you cannot distinguish lines by their ringers.
*7 The flash time depends on your telephone exchange or host PBX. Consult your PBX
supplier if necessary. The setting should stay at “700ms” unless pressing
{FLASH}
fails to pick up the call waiting call.
*8 Generally, the line mode setting should not be adjusted. If k or l is not displayed
on the handset or the LINE1 or LINE2 indicator on the base unit does not light properly
when another phone connected to the same line is in use, you need to change the line
mode to “A”.
Set flash time
*1*7
Line1
{0}{5}{2}{1} {1}: <700ms>
{2}: 600ms {3}: 400ms
{4}: 300ms {5}: 250ms
{6}: 110ms {7}: 100ms
{8}: 90ms
–
Line2
{0}{5}{2}{2}
Set line mode
*1*8 Line1 {0}{5}{3}{1} {1}: A {2}: <B> –
Line2 {0}{5}{3}{2}
Voice enhancer
{5} {1}: On {0}: <Off> 26
Feature Feature code Setting code Page