Pioneer PDP-436RXE - Manual (Page 32)

32
En
Basic Adjustment Settings 08
Power Control
Power Control provides convenient functions for power saving.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select “Power Control” ( / then ENTER).
3
Select “Energy Save” ( / then ENTER).
4
Select “Save1”, “Save2”, or “Picture Off” ( / then
ENTER).
5
Press HOME MENU to exit the menu.
NOTE
• The PIC OFF indicator on the front of the Plasma Display
lights up in orange when the Picture off is selected.
No Signal off
The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select “Power Control” ( / then ENTER).
3
Select “No Signal off” ( / then ENTER).
4
Select “Enable” ( / then ENTER).
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Plasma Display after a TV
programme finishes.
No Operation off
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select “Power Control” ( / then ENTER).
3
Select “No Operation off” ( / then
ENTER).
4
Select “Enable” ( / then ENTER).
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Item Description
Standard Does not decrease the picture brightness.
Save1 Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2 Decreases the picture brightness and lowers
power consumption.
Picture Off Deactivates the screen to save power. To restore
the screen display, press any button other than
i
+/i – and e.
This setting is not memorised by the system.
Item Description
Disable
(factory default) Does not place the system into the standby
mode.
Enable Places the system into the standby mode if no
signal is received for 15 minutes.
Item Description
Disable
(factory default) Does not place the system into the standby
mode.
Enable Places the system into the standby mode if no
operation is performed for three hours.