Rack mounting – Panasonic AJ-HD150FE User Manual

Page 102

Advertising
background image

– 102 –

Rack mounting

The unit can be mounted into a 19-inch standard rack if the optional rack-mounting adapters
(AJ-MA75P) are used. For the installation rails, it is recommended that the rail and bracket
for 18

q

length (model number CC3061-99-0400) of Chassis Trak be used. If an even greater

clearance is to be left between the VTR and rack when the VTR is pulled out, however, it is
recommended that the 22

q

long Chassis Trak (model number CC-3001-99-0191) be used.

(The complete slide rail and bracket unit is not available from Panasonic.) For further details,
consult with your dealer.

1

Attach the inner members of the slide rails. Refer to Table 1 for the places where they
are to be secured with the screws.

The length of the screws used is subject to restriction. Use screws which are less than
10 mm long in their place.
6 screws must be used to secure each inner member. When using the 22

q

long slide

rails, secure the screws at 4 locations.

2

Attach the outer member brackets to the rack.
Check that the height is the same for the left and right brackets.

3

Remove the four screws at the front for attaching the left and right side panels.

4

Attach the AJ-MA75P rack-mounting adapters with included 4 screws.

5

Remove the 4 rubber legs from the bottom of the unit, and install the unit in the rack.
After the unit has been installed, check that it moves smoothly along the rails.

<Notes>

Keep the temperature inside the rack to between +5°C and +40°C.

Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out.

Attach the inner members at the
same symmetrical positions on the
left (L) side.
Note: The letters “A” to “H” are not
actually marked on the side panels.

Table 1 Locations where the screws are secured on right (R) side of

inner members of slide rails

18

q

Chassis Trak

CC3061-99-0400

B, E, G

Part Number

Screw holes to be used

22

q

Chassis Trak

CC3001-99-0191

C, H

Rack-mounting adapters

Fasten it to the
rack with set
screws.

Standard rack

A

B

C

D

E

F

G

H

Advertising