Audio adjustments operation modes 42, Operation mode marks 42, Way network mode – Pioneer SUPER TUNERIII DEH-P8650MP User Manual

Page 42: Standard mode, Adjusting the audio easily 42, Adjusting the audio finely 42, Operation modes, Audio adjustments, Operation mode marks, Adjustingthe audio easily

Advertising

Operation modes

This unit features two operation modes: the 3-

way network mode (NW) and the standard

mode (STD). You can switch between modes

as desired. Initially, the DSP setting is set to

the standard mode (STD). (Refer to Switching

the DSP setting mode on page 6.)

! The 3-way network mode (NW) lets you cre-

ate a 3-way multi-amp, multi-speaker sys-

tem with separate speakers for

reproduction ofhigh, middle and low fre-

quencies (bands), each driven by a dedi-

cated power amp. The 3-way network mode

provides network and time alignment func-

tions, two functions essential for a multi-

amp, multi-speaker system, to enable pre-

cise control over settings for each fre-

quency range.

! The standard mode (STD) lets you create a

4-speaker system with front and rear speak-

ers, or a 6-speaker system with front and

rear speakers and subwoofers.

Important

When no power is supplied to this unit because
ofa change ofthe car battery or for some similar
reason, the microcomputer ofthis unit is re-
turned to its initial condition. Ifthis happens, all
memorized adjusted audio settings are erased.
When you have completed audio setting adjust-
ment, be sure to record the settings shown on
page 69.

Operation mode marks

This manual uses the following marks to make

the description clear.

: This mark indicates a function only in

NW mode or an operation in NW mode.

: This mark indicates a function available

only in STD mode or an operation in STD

mode.

! The functions and operations which do not

carry either mark are commonly used in

the NW and STD modes.

3-way network mode