Messages 64, Understanding auto ta and eq error, Understanding error message on rewriting – Pioneer SUPER TUNERIII DEH-P8650MP User Manual

Page 64: The entertainment displays 64, Understandingbuilt-in cd player error messages, Understandingauto ta and eq error messages, Additional information

Advertising
background image

Understandingbuilt-in CD

player error messages

When problems occur during CD play an error

message may appear on the display. Ifan

error message appears, refer to the table

below to see what the problem is and the sug-

gested method ofcorrecting the problem. If

the error cannot be corrected, contact your

dealer or your nearest Pioneer Service Center.

Message

Cause

Action

ERROR-11, 12,

17, 30

Dirty disc

Clean disc.

ERROR-11, 12,

17, 30

Scratched disc

Replace disc.

ERROR-10, 11,

12, 17, 30, A0

Electrical or me-

chanical

Turn the ignition

ON and OFF, or

switch to a differ-

ent source, then

back to the CD

player.

ERROR-22, 23 The CD format

cannot be played

back

Replace disc.

ERROR-44

All tracks are

skip tracks

Replace disc.

Understandingauto TA and

EQ error messages

When correct measurement ofcar interior

acoustic characteristics is not possible using

the auto TA and EQ, an error message may ap-

pear on the display. Ifan error message ap-

pears, refer to the table below to see what the

problem is and the suggested method ofcor-

recting the problem. After checking, try again.

Message

Cause

Action

Error check

MIC

Microphone is

not connected.

Plug the supplied

microphone se-

curely into the

jack.

Error check

front SP, Error

check FL SP,

Error check FR

SP, Error check

RL SP, Error

check RR SP,

Error check

SW

The microphone

cannot pick up

the measuring

tone ofa speaker.

! Confirm that the

speakers are con-

nected correctly.

! Cancel muting

the front speaker

units.

! Correct the input

level setting ofthe

power amp con-

nected to the

speakers.

! Set the micro-

phone correctly.

Error check

noise

The surrounding

noise level is too

high.

! Stop your car in

a place that is as

quiet as possible,

and switch off the

engine, air condi-

tioner or heater.

! Set the micro-

phone correctly.

Not available The operation

mode is set to

NW mode.

The auto TA and

EQ function does

not work in NW

mode.

Understandingerror

message on rewriting the

entertainment displays

When problems occur during rewriting the en-

tertainment displays an error message may

appear on the display. Ifan error message ap-

pears refer to the table below to see what the

problem is and the suggested method ofcor-

recting the problem. Ifthe error cannot be cor-

rected, contact your dealer or your nearest

Pioneer Service Center.

Additional Information

En

64

Appendix

Advertising