Panasonic KXTG4321 - Manual (Page 43)

Useful Information
43 For assistance, please visit http://www.panasonic.com/help
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the
batteries from the handset, and then insert the batteries into the handset again.
General use
Programmable settings
Problem Cause/solution
The unit does not work.
L
Make sure the batteries are installed correctly
(page 11).
L Fully charge the batteries (page 12).
L Check the connections (page 10).
L Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
L The handset has not been registered to the
base unit. Register the handset (page 26).
I cannot hear a dial tone. L The base unit’s AC adaptor or telephone line
cord is not connected. Check the connections.
L If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the
wall jack directly. If the unit operates properly,
check the splitter.
L Disconnect the base unit from the telephone
line and connect the line to a known working
telephone. If the working telephone operates
properly, contact our service personnel to
have the unit repaired. If the working
telephone does not operate properly, contact
your service provider/telephone company.
The indicator on the handset
flashes slowly. L New messages have been recorded. Listen to
the new messages (page 32).
L New voice mail messages have been
recorded. Listen to the new voice mail
messages (page 37).
Problem Cause/solution
I have changed the display
language to a language I
cannot read. L Change the display language (page 14).
TG43xx_OI.book Page 43 Tuesday, December 11, 2007 2:04 PM