Pioneer VSX-819H-S - Manual (Page 20)

Connecting up 03
20
En
Connecting to the front panel
video terminal
Front video connections are accessed via the
front panel using the
INPUT SELECTOR or
VIDEO button on the remote control. There are
standard audio/video jacks. Hook them up the
same way you made the rear panel connections.
• Push down on the PUSH OPEN tab to
access the front video connections.
Connecting antennas
Connect the AM loop antenna and the FM wire
antenna as shown below. To improve reception
and sound quality, connect external antennas
(see Using external antennas on page 21).
1 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
2 Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. a) then
clip the loop onto the stand (fig. b).
3 Place the AM antenna on a flat surface
and in a direction giving the best reception.
4 Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don’t drape
loosely or leave coiled up.
This receiver
MASTER
VOLUME SPEAKERS CONTROL MULTI-ZONE ON/OFF
MCACC
SETUP MIC
VIDEO INPUT R L AUDIO VIDEO iPod USB
L VIDEO R
AUDIO/VIDEO OUTPUT
Video camera
(etc.)
VIDEO INPUT
R L AUDIO VIDEO
iPod
USB
ANTENNA
AM
LOOP
2
1
3
4
fig. a fig. b
VSX-819H_RLF.book 20 ページ ２００９年１月２０日 火曜日 午前１０時３６分