Pioneer VSX-819H-S - Manual (Page 50)

Using the tuner 08
50
En
3 Press PRESET / to select the station
preset you want.
You can also use the number buttons.
4 Press ENTER.
After pressing
ENTER, the preset number stop
blinking and the receiver stores the station.
Listening to station presets
You will need to have some presets stored to do
this. See Saving station presets on page 49 if
you haven’t done this already.
• Press PRESET / to select the station
preset you want.
• You can also use the number buttons on
the remote control to recall the station
preset.
Naming preset stations
For easier identification, you can name all of
your preset stations.
1 Choose the station preset you want to
name.
See Listening to station presets above for how
to do this.
2 Press TUNER EDIT twice.
The cursor at the first character position is
blinking on the display.
3 Input the name you want.
Choose a name up to eight characters long.
• Use the PRESET / buttons to select
character position.
• Use the TUNE / buttons to select
characters.
• The name is stored when ENTER is
pressed.
Tip
• To erase a station name, follow steps 1 and
2, and press ENTER while the display is
blank. Press TUNER EDIT while the display
is blank, to keep the previous name.
• Once you have named a station preset,
press DISPLAY to show the name. When
you want to return to the frequency display,
press
DISPLAY several times to show the
frequency.
Changing the frequency step
If you find that you can’t tune into stations
successfully, the frequency step may not be
suitable for your country/region. Here’s how to
switch the setting:
1 Switch the receiver into standby.
2 While holding down the ‘TUNE –’ button,
press and hold the  STANDBY/ON button
for about two seconds.
The channel tuning step alternates between
10K STEP and 9K STEP each time you do this.
08_using_tuner.fm 50 ページ ２００９年２月６日 金曜日 午後１時２６分