Pioneer VSX-819H-S - Manual (Page 66)

Additional information 12
66
En
Chapter 12:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Take a look at the other
components and electrical appliances being used, because sometimes the problem may lie there.
If the trouble isn’t sorted out even after going through the checks below, ask your nearest Pioneer
authorized independent service company to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
Problem Remedy
The power does not turn on. • Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear panel. This
could cause the receiver to shut off automatically.
The receiver suddenly switches
off. • After about a minute (you won’t be able to switch the unit on during this time),
switch the receiver back on. If the message persists, call a Pioneer authorized
independent service company.
No sound is output when a
function is selected. • Make sure the component is connected correctly (refer to Connecting up on page 12).
• Press
MUTE on the remote control to turn muting off.
• Press SPEAKERS to select the proper speaker set (see Switching the speaker
system on page 25).
• Press
SIGNAL SEL to select the proper input signal (see Choosing the input signal
on page 41).
No image is output when a
function is selected. • Make sure the component is connected correctly (refer to Connecting up on page 12).
• Select the correct component (use the
MULTI CONTROL buttons).
• Check The Input Assign menu on page 45 to make sure you’re assigned the
correct input.
• The video input selected on the TV monitor is incorrect. Refer to the instruction
manual supplied with the TV.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have an LFE channel.
• Switch the subwoofer setting in Speaker Setting on page 43 to
YES or PLUS.
• Switch the LFE ATT (LFE Attenuate) on page 40 to LFEATT 0 or LFEATT 10.
No sound from surround or
center speakers. • Connect the speakers properly (refer to page 22).
• Refer to Speaker Setting on page 43 to check the speaker settings.
• Refer to Channel Level on page 44 to check the speaker levels.
The PHASE CONTROL feature
doesn’t seem to have an
audible effect.
• If applicable, check that the lowpass filter switch on your subwoofer is off, or the
lowpass cutoff is set to the highest frequency setting. If there is a
PHASE setting on
your subwoofer, set it to 0º (or depending on the subwoofer, the setting where you
think it has the best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers (see Speaker
Distance on page 45).
VSX-819H_RLF.book 66 ページ ２００９年１月２０日 火曜日 午前１０時３６分