Panasonic SC-AK300 - Manual (Page 6)

Before using
6
RQT6131
Connector
Appliance inlet
Approx. 6 mm
Adhesive tape
FM indoor antenna
FM AN
T
(
)
For Australia and
New Zealand For Europe
FM AN
T
(
)
2
1
3
4
For Australia and
New Zealand For Europe
AM loop antenna
1
2
3
To household
mains socket
4
LOOP
EXT
AM ANT
LOOP
EXT
AM ANT
1
2
GND
1
2
Basic connections (for supplied
accessories)
•
Plug the AC mains lead into a household mains socket only after all
other connections have been made.
•
To prepare the antenna wires and speaker cords, twist the vinyl
cover tip and pull off.
1
Connect the FM indoor antenna.
Tape the antenna to a wall or column, in a position where radio
signals are received with the least amount of interference.
Note
For best reception sound quality:
An FM outdoor antenna is recommended. (See page 7.)
2
Connect the AM loop antenna.
After attaching the antenna, turn on the system and tune in a
broadcast station. Put the antenna where the reception is best
and interference is minimal.
3
Connect the speaker cables.
Connect each end of the speaker cables to the terminal lever of
the same colour so (+) and (–) are correct. Never allow the
exposed wires to contact each other when connected.
Incorrect connection can damage the unit.
Caution
•
Use only the supplied speakers.
The combination of the main unit and speakers provide the
best sound. Using other speakers can damage the unit and
sound quality will be negatively affected.
Caution
• Use the speakers only with the recommended
system.
Failure to do so may lead to damage to the amplifier
and/or the speakers, and may result in the risk of
fire.
Consult a qualified service person if damage has
occurred or if you experience a sudden change in
performance.
•
Do not attach these speakers to walls or ceilings.
4
Connect the AC mains lead.
FOR UNITED KINGDOM ONLY
READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 4 BEFORE CONNECTION.
Insertion of connector
Even when the connector is perfectly inserted, depending on
the type of inlet used, the front part of the connector may jut out
as shown in the drawing.
However there is no problem using the unit.
Note
The included AC mains lead is for use with this unit only. Do
not use it with other equipment.
Connections
Blue (–)
Red (+)
Black (–)
Gray
Blue
Black
Gray (+)
Red