Parkside PABS10.8-LI - Manual (Page 11)

12 GB
contact with the metal screw head. Use a coun-
tersinker.
When drilling into wood, metal and other
materials:
˽
With small diameter drill bits use a high drill
speed. For large diameter drill bits, use a low
drill speed.
˽
For hard materials, select a low drill speed.
For soft materials, select a high drill speed.
˽
Secure or fix down the workpiece (if possible)
in a clamp or vice.
˽
Mark the intended position of the hole with a
centre punch or a nail and select a low drill speed
for drilling.
˽
Take the rotating drill bit out of the hole frequently
so that swarf or drill dust can be re-moved and
the hole and tool is ventilated.
Drilling in metal:
˽
Use a metal drill bit (HSS). For the best results,
you should cool the bit with oil. Metal drill bits
can also be used to drill into plastic.
Drilling in wood:
˽
Normally you should use a wood drill with a
centring point. You can screw small screws into
soft wood without the need for pre-drilling.
© Cleaning and Maintenance
CAUTION! Place the direction of rotation
switch 5 into the middle position before carrying
out any tasks on the device, e.g. changing tools or
maintenance, or before transporting or storing the
device. Inadvertent operation of the ON / OFF
switch
6 may result in injury.
Always pull the mains adapter 13 out of the mains
socket and remove the battery pack before you
clean or maintain the device.
The Cordless Drill / Screwdriver is maintenance-free.
˽
Always keep the device clean, dry and free of
oil or grease.
˽
Clean the device immediately after you have
finished using it.
˽
Do not allow any liquids to enter the device.
Use a cloth to clean the housing.
˽
Never use petrol, solvents or cleaning agents
that might attack plastic.
© Service
WARNING!
Have your device
repaired at the service centre or by
qualified specialist personnel using
original manufacturer parts only. This
will ensure that your device remains safe to use.
WARNING! If the plug or lead needs
to be replaced, always have the
replacement carried out by the manu-
facturer or its service centre. This will
ensure that your device remains safe to use.
© Warranty
This appliance is guaranteed for 3 years
from the date of purchase. It has been care-
fully produced and meti-culously checked
before delivery. Please keep your receipt
as proof of purchase. Contact your service
centre by telephone in case of questions
pertaining to the warranty. Your goods can
be transmitted free of cost only in this man-
ner. This warranty applies only to the initial
purchaser and is non-transferable.
The warranty covers only material or manufactur-
ing faults, not normal wear or damage to fragile
parts such as switches or rechargeable batteries.
The appliance is intended solely for private, not
commercial, use.
If this product has been subjected to improper or in-
appropriate handling, abuse, or interventions not
carried out by one of our authorised sales and
service outlets, the warranty will be considered void.
This warranty does not affect your statutory rights.
Preparing the tool for use / Cleaning and Maintenance / Service / Warranty