Philips PCA82CR - Manual (Page 43)

PHILIPS CD-ROM DRIVE USER’S MANUAL
22 A 24
A.2 Setting Master and Slave
Jumpers
Whether your PC system regards your CD-ROM drive as a
master device or a slave device depends on which of
the “


” (master) and “

” (slave) jumpers on the back
of the drive is capped.
or
Slave Mode Master Mode
Figure A-3 Jumper Settings of Slave Mode and Master Mode
Your CD-ROM drive is shipped with the “  ” jumper
capped, In spite of this, note from Figure A-3 that
capping the “

” jumper is optional for Slave mode.
To set your CD-ROM drive as a master device, simply
remove the cap from the “  ” jumper and place it over
the “


” jumper.
Note: 1. The “MA” and “SL” jumpers cannot be both
capped at the same time.
2. A system halt will occur if the “MA” or “SL”
jumper is set in conflict with the other
device connected to the same IDE port. An
IDE port cannot contain two master devices or
two slave devices at any moment of time.