Panasonic CF-Y4 User Manual
Page 61
61
Impo
rtan
t Information
Set the Product Recovery DVD-ROM, and execute step D.
D
Press the F10 key.
At the confirmation message, select [Yes] and press the Enter key.
The Setup Utility will close, and the computer will restart.
If [Enter Password] is displayed during the following procedure, enter the
Supervisor Password or User Password.
<When the hard disk backup function has been enabled>
When the message [The Backup function has been enabled...] appears,
press the Y key.
E
When the message "Select a number" is displayed, press the 2 key and
perform [2. [Erase HDD]].
(You can cancel this operation by pressing the 0 key.)
The confirmation message will be displayed.
<When the hard disk backup function has been enabled>
When the message [The Backup function has been enabled...] appears,
press the Y key.
When the message [Computer must be rebooted in order to execute
[Erase HDD]] appears, press the R key.
F
Press the Y key.
Hard Disk Data Erase Utility will start.
G
When [<<<Start menu>>>] is displayed, press the Enter key.
H
The approximate time required for erasing data will be displayed.
Press the Space key.
I
At the confirmation message, press the Enter key.
The operation of erasing the hard disk starts.
z
If necessary, the “hard disk data erase” operation can be cancelled
after it has begun by pressing the Ctrl+C key.
If the operation is cancelled before being completed, a part of data will
not be erased.
J
The message "Hard disk data has been deleted" will be displayed.
Remove the Product Recovery DVD-ROM, and press any key to shut
down the computer.
z
If a problem occurred during the operation, an error message will be
displayed.