Panasonic RX-ES20 - Manual (Page 14)

14
RQT5189
Tips on Recording
Erasure prevention
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown.
Erasing recordings
1
Insert the cassette with the side to be erased facing up.
2
Press [ n TAPE/CD] to switch to TAPE mode.
3
Press [ [ / K ].
A
B
Recording CDs
Normal recording
Preparation:
• Insert a CD (
\ page 10).
• Wind on the leader tape.
■
1 Press [
0
DECK] to open the deck.
Load a cassette with the side for recording facing up and close
the deck by hand.
■
2 Press [ n TAPE/CD] to switch to CD mode.
Each time you press the button:
TAPE
↔
Cd.
■
3 Press [ [ / K ] to start recording.
CD play and recording start at the same time.
The cassette stops when the CD finishes.
To stop recording
Press [ n TAPE/CD].
■ D To pause recording
Press [ [ / K ].
Press again to resume recording.
To continue recording from another CD on the same cas-
sette
1
Press [ 0 CD] and replace the CD.
2
Press [ [ / K ].
To record selected tracks
1
Do step
■ 1 ., then program the tracks ( \ page 12).
2
Press [ [ / K ].
To skip unwanted tracks
1
Press [ [ / K ] to pause recording (the CD also pauses).
2
Turn [TIME/PRESET TUNE CD SKIP ] so the next track you
want to record is displayed.
3
Press [ [ / K ] to resume recording.
■
C
7
A
To protect tapes against further recording
7
B
7
2
7
1
7
3
7
C
7
3
7
1
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
7
2
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
DECK
TAPE ⁄ CD
Side to be recorded facing up
Insert the cassette with the exposed tape facing you.
1
3 2
7
D
Recording
Tab for side “B” Tab for side “A”
Side A
Normal position tape
To re-record
A
Adhesive
tape