Adjusting the black balance, Atw (auto tracking white) function, White balance and black balance – Panasonic AG-DVC80 User Manual

Page 31

Advertising
background image

Adjusting the black balance

There is normally no need to re-adjust the black
balance. Adjustment is required only in the
following cases.

O

When the camera recorder is to be used for
the first time

O

When the camera recorder is to be used after
it has not been used for an extended period

O

When the camera recorder is to be used in a
situation where the ambient temperature will
vary significantly

The white balance is adjusted automatically by
pressing the AWB button.
If the button is then held down, the black
balance is adjusted.

O

When the AWB button is pressed, the white
balance is adjusted first. Therefore, ensure
that the conditions under which the white
balance is adjusted are satisfied before
pressing the button.

O

While recording is in progress, the black
balance cannot be adjusted.

31

White balance and black balance

ATW (Auto Tracking White)
function

The ATW function can be allocated to the
WHITE BAL switch (A, B or PRST position)
using the ATW item on the setting menu SW
MODE screen. (See page 39)
Similarly, the ATW function can be allocated to
the AUTO button using the ATW item on the
setting menu AUTO SW screen. (See page 40)

When material is shot using the ATW function, it
is recorded while the white balance is being
continually adjusted automatically.

O

The ATW function automatically identifies the
shooting environment and adjusts the white
balance optimally. In some environments, a
slight adjustment error may arise.
If an extremely accurate white balance
adjustment is required, adjust the white
balance by following the instructions on the
previous page.

ABB ACTIVE

Message that appears while adjustment is
underway

ABB END

Message that appears upon completion of the
adjustment

Advertising
This manual is related to the following products: