Panasonic CQ-C1305L - Manual (Page 12)

General
[VOL] (Volume) [SOURCE] (Source)
selects a source.
[PWR] (Power)
toggles power on/off.
Power On/Off
Set your car’s ignition switch to the ACC or ON position.
Power on: Press [SOURCE] (PWR).
Power off: Hold down [SOURCE] (PWR) for
more than 1 second.
Source Selection
Press [SOURCE] to change the source.
Radio Disc Player AUX IN
Volume Adjustment
(Setting Range: 0 to 40, Default: 18)
Turn [VOL].
Mute
ON: Press [MUTE]. ( lights.)
OFF: Press [MUTE] again.
SQ (Sound Quality)
SQ is a function that can call up various sound types at the
touch of button in accordance with your listening music type.
Press [SQ] to select the sound type (SQ) as
follows:
(FLAT) fl at frequency response:
does not emphasize any part.
(Default)
(ROCK) speedy and heavy
sound:
exaggerates bass and treble.
(POP) wide-ranged and deep
sound:
slightly emphasizes bass and
treble.
(VOCAL) clear sound:
emphasizes middle tone and
slightly emphasizes treble.
Notes:
• If no operation takes place for more than 5 seconds in the
SQ selection mode, the display returns to the regular mode.
• Settings of SQ, bass and treble are infl uenced one another.
If such an infl uence causes distortion to the audio signal,
readjust bass/treble or volume.
• For further information on Bass, Treble, Balance and Fader
settings, refer to Audio Settings.
General Operations
[MUTE]
toggles mute on/off. *[AUX] (AUX IN) (3.5 mm œ stereo)
From line output of external sound/audio
device (ex. Silicon-audio player, HDD
player, etc.)
Remote Control Sensor
*
Caution
• Set the volume level to low
enough before the AUX
connection is completed.
Failure to observe this, the
loud noise may come out and
damage your speakers and your
hearing.
*AUX IN:
[SQ] (Sound Quality)
selects a sound type
(SQ).