Pioneer DC500 - Manual (Page 20)

EN-20
Charging the Battery
The state-of-charge of the battery will affect the performance of the digital still camera. To maximize battery
performance and lifetime, it is recommended that you fully charge the battery using the optional AC power
adapter and then fully discharge it (through normal use) at least one time. Please note that the digital still
camera must be powered off before charging the battery. Otherwise, the power will be provided only to the
digital still camera.
1. Place the camera on the cradle. Connect the AC power adapter
to the jack on the cradle labeled "DC IN 5V".
2. Connect the other end of the AC power adapter to a wall
outlet.
Charging time differs depending on the ambient
temperature and the status of battery.
Use the appropriate international plug adapter (included) depending on the type of electrical outlet in your
country.
The digital still camera must be used with the specified AC power adapter. Damage caused by the use of an
incorrect adapter is not covered under the warranty.
Always make sure that the digital still camera is off before removing the battery.
The battery may feel warm after it has been charged or immediately after being used. This is normal and not a
malfunction.
When using the digital still camera in cold environments, keep the digital still camera and its battery warm by
holding it inside your jacket or other warm protective environment.
The battery is not fully charged at shipment and must be fully charged before being used.