Panasonic UF-490 - Manual (Page 59)

Receiving Documents
59
Basic
O
p
era
ti
o
n
s
When your machine is set to this mode, it will immediately begin to receive documents automatically when a
call is received.
Setting the Fax Mode
Operation of Fax Mode
Your machine will begin receiving automatically when a fax call is received.
Your machine is equipped with a unique feature called TAM Interface which enables it to automatically
switch a single telephone line either to Fax or TAM. You can connect most TAMs in the market to your
machine and use your existing telephone line very efficiently. However, some TAMs may not be compatible
with this machine. Answering Services (Voice Mail) provided by your Local Phone company are not
compatible with this feature. For the operation of your TAM, please refer to the Operating Instructions of the
TAM.
Fax Mode
1 Change Fax Parameter No. 16 (OUT MODE) to 1: Fax.
(See page 33)
2
Make sure that the lamp goes on.
RCV MODE=FAX
TAM (Telephone Answering Machine) Interface Mode
Installing your TAM
1 1. Remove the telephone line cable of your
TAM from the wall jack.
2. Plug the telephone line cable of your
TAM into the TEL jack on the rear of the
fax machine as shown.