Preparation 05 – Pioneer PRO-950HD User Manual

Page 19

Advertising
background image

19

En

Preparation

05

speaker cables

Note

• Press the lever and insert the end of the cable.

• When you release the lever, it

clamps onto the speaker cable.·

Caution

• Be sure to turn the connected

devices off and remove the power
cord from the wall outlet beforehand when changing the
connection or installation method.

• If you insert the speaker cable too far so that

the insulation is touching the speaker
terminal, you may not get any sound.

• Check if the end of the speaker cables are securely connected

to the terminals by slightly tugging on the cable after making
connections. Loose connections may result in sound dropouts
or noise.

• If there is a short in the

 and  cables caused by an exposed

lead wire, excessive load may be applied to the plasma display,
resulting in interrupted operation or malfunction.

• Incorrect connections of the speaker cable to the right or left of

the plasma display terminals with respect to the polarity may
result in insufficient stereo sound effects, delivering poor bass
sounds or unstable sound image.

• Bundle the cable without pulling.

Connecting the speaker cables
to the rear of plasma display.

Gray

Gray

Black

Black

Red

Red

Connecting the speaker cables
to the speaker.

Connect the cables correctly with respect to
the polarity of the speaker terminals, that is,

cable (Gray) to

terminals (Red) and

cable (Black) to

terminals (Black).

Gray

Black

Black

Red

Speaker terminal

Speaker terminal

Speaker cable

Speaker terminal

Connect the cables correctly with respect to
the polarity of the plasma display speaker
terminals, that is,

cable (Gray) to

terminals (Red) and

cable (Black) to

terminals (Black).

Lever

PRO1150HD.book Page 19 Tuesday, April 17, 2007 9:34 AM

Advertising