Pioneer PRO-950HD - Manual (Page 22)

22
En
Preparation 05
2 Attach the stand at the points indicated by the arrows
and tighten the installation bolts (2) and (1) firmly using
a screwdriver.
Installation bolts (1): M8 x 23 mm (black) for PRO-950HD
M8 x 23 mm (black) for PRO-1150HD
Installation bolts (2): M8 x 60 mm (black) for PRO-950HD
M8 x 40 mm (black) for PRO-1150HD
3 Replace the plasma display to stand upright.
For speaker installation, see Installing the Pioneer
speaker on pages 16 (PRO-1150HD only).
Note
• Be sure to install the plasma display in a flat, stable location.
• Insert the screws into the holes vertically and tighten them.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma display lying flat on a table or similar
surface.
• When lying the plasma display down, be careful not to scratch
or damage it.
• If the speaker has been installed, it is recommended to detach
the speaker before attaching the stand (for PRO-1150HD only).
Installation bolts (1) (Step 2)
Installation bolts (2) (Step 1)
Screw hole with “T” inscribed
PRO1150HD.book Page 22 Tuesday, April 17, 2007 9:34 AM