The initial setup menu 16 – Pioneer DVR-550HX-S User Manual

Page 126

Advertising
background image

The Initial Setup menu

16

126

En

Video In/Out

Input Colour
System

Next Screen

Proceed to the next screen to set the input colour
system for the external input and the built-in TV
tuner. Use the

Smart Jog

or

INPUT SELECT

buttons

to change the preset or external input. On the default

Auto

setting the recorder can generally correctly

detect whether the input signal is PAL, SECAM, 3.58
NTSC or PAL-60, but in some cases you may have to
set it manually if the picture is displayed incorrectly.

• Input Colour System cannot be set when the recorder is in D.TV mode.
• See also About the input colour system on page 136 for more information on this setting.

Component Video
Out

Interlace •

Select if your monitor/TV is not compatible with
progressive-scan video.

Progressive

Select if your monitor/TV is progressive-scan
compatible. Check the operating instructions that
came with your monitor/TV if you’re not sure.

For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than

RGB

.

If your TV is incompatible with progressive scan video and you select

Progressive

, you will not be able to see any

picture at all. In this case, press

OPEN/CLOSE

while holding down the

(Stop) button on the front panel to

switch to

Interlace

(this also switches Screen Resolution on page 133 to the default setting).

When the HDMI signal is output, no video is output from the

COMPONENT VIDEO OUT

.

AV1 Out

Video •

Sets the

AV1 (RGB)-TV

SCART output to standard

composite video (compatible with all TVs).

S-Video

Sets the

AV1 (RGB)-TV

SCART output to S-video.

Recommended if you are using a long SCART cable.

RGB

Sets the

AV1 (RGB)-TV

SCART output to RGB. Good

quality but check your TV for compatibility. Note that
on this setting signals from the built-in tuner and
from external inputs is not output when the recorder
is in TV mode.

If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case

either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on
page 152).

The Component Video Out setting (see above) has no effect when AV1 Out is set to

RGB

.

When the HDMI signal is output, the AV1 Out outputs the composite video signal even when it is set to

RGB

.

Setting

Options

Explanation

DVR550HXS_WV_EN.book 126 ページ 2007年3月30日 金曜日 午前10時48分

Advertising