Panasonic KX-TG1855AL - Manual (Page 13)

Preparation
13
Battery level
Panasonic Ni-MH battery
performance (supplied batteries)
Note:
L
It is normal for batteries not to reach
full capacity at the initial charge.
Maximum battery performance is
reached after a few complete cycles of
charge/discharge (use).
L Actual battery performance depends
on a combination of how often the
handset is in use and how often it is
not in use (standby).
L Even after the handset is fully
charged, the handset can be left on
the base unit or charger without any ill
effect on the batteries.
L The battery level may not be
displayed correctly after you replace
the batteries. In this case, place the
handset on the base unit or charger
and let it charge for at least 7 hours.
Turning the power
on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Setting up the unit
before use
Display language
1
{ih}
i {j/OK}
2 Press {^} or {V} to select
“Handset Setup”. i {>}
3 Press {^} or {V} to select
“Display Setup”. i {>}
4 Press {^} or {V} to select
“Select Language”. i {>}
5 Press {^} or {V} to select the
desired language. i {>} i
{ih}
Note:
L
If you select a language you cannot
read: {ih} i {j/OK} i {^} 3
times i {>} i {V} 2 times i
{>}
2 times i {^}/{V}: Select the
desired language. i {>} i
{ih}
Battery icon Battery level
5 High
6 Medium
7 Low
L
When flashing:
Needs to be
charged.
Operation Operating
time
In continuous use Approx. 17
hours max.
In continuous
standby mode Approx. 180
hours max.
TG1855-1857AL(e-e).book Page 13 Thursday, July 12, 2007 5:31 PM