Panasonic CF-07 Series - Manual (Page 16)

16
G
e
ttin
g
S
ta
rte
d
First-time Operation
7
At [Networking Settings], select [Typical settings], then select [Next].
8
At [Workgroup or Computer Domain], select [No, this computer is not on a
network, or is on a network without a domain], then select [Next].
The computer will restart.
If “Yes, make this computer a member of the following domain” is se-
lected, the following message may be displayed: [An invalid domain was
specified. Would you like to proceed for now and try joining a domain
later?]. In this case, select [Yes]. After selecting [Yes], the computer will
restart automatically, but sometimes the [Starting Windows] message will
remain on the screen, and windows will not start up. If this happens, hold
Alt
down while pressing Tab until [Network Identification Wizard]
is displayed on top, and follow the instructions on the screen.
NOTE
NOTE
It may take two to three minutes until the next screen is displayed. Wait,
and do not press any keys, or touch the mouse, etc.
6
Enter the correct date, time and the time zone, then select [Next].
When creating a new user account:
If you make mail settings, create password reset disks ( page 20), or
conduct other related operations before creating the user account, you
will be unable to use any previous mail history or settings.
When you create the first new account, you can only select [Computer
administrator].
Once a “Computer Administrator” account has been created, you can cre-
ate additional limited user accounts.
Note also that only the added user account will be displayed in the Wel-
come screen. The account for the administrator created during Windows
setup will not be displayed.
NOTE
9
Enter your administrator password and select .
10
Select [Start]-[Control Panel]-[User Accounts]-[Create a new account] and follow
the instructions on the display to create a user account, then restart the computer.
CAUTION
Remember this password! If the password is forgotten, Windows can-
not be operated. You can create a password reset disk beforehand (
page 20).